Simultaneously you can easily hear which fans are more audible and you can also find out the minimum power needed by trying to set it at very low percentages. You can completely stop all fans in your PC (when at idle and just for testing obviously), then one by one set each fan at 100% to hear which option operates which fan. What you should do is to increase the power for those fans that previously weren't spinning carefully until they work as intended. Configuration NBFC comes with pre-made profiles. Installation NBFC can be installed as nbfc AUR or nbfc-git AUR. It comes with a powerful configuration system, which allows to adjust it to many different notebook models, including some of the latest ones. It doesn't seem like there is support for monitoring the Embedded Controller on ASUS boards (or at least on mine). Fan Xpert 4 Digi+ VRM Control All-Around Energy Efficiency The Energy Processing Unit (EPU) automatically optimizes power consumption and maximizes energy savings with Away mode a smart setting that creates an extreme energy-saving scenario by shutting down unused I/O controllers. Ultimately Id like to control that fans speed with FanControl. I noticed this too when I lowered some fans too much in BIOS and they weren't spinning at all. NBFC is a cross-platform fan control solution for notebooks. HWiNFO64 reports the chipset fan speed under 'ASUS EC'. Silent fans can spin at lower RPM's and can thus operate at lower power. ASUS Fan Extension Card support Smart protection Each header can dynamically reference three thermal sensors, and via Fan Xpert 4 you can even map the temperature of supported ASUS graphics cards to optimize cooling for GPU and CPU-intensive tasks. Gigabyte Aorus Elite paired with a 3900x and one SN550 NVME in a thermaltake S300 case. Fans have a specific operational RPM range which you can't override by lowering or increasing the power. Just asking because I've had bad experiences in the past with chipset fans. So if you accidentally reduce the power too much by any means (BIOS or programs) the fan will not spin. You made some good points, however, I don't think it's because of the program itself but because all fans have a certain minimum torque required for spinning.
0 Comments
Leave a Reply. |